diff options
Diffstat (limited to 'arch/arm64/boot/dts/qcom/sm8150-hdk.dts')
| -rw-r--r-- | arch/arm64/boot/dts/qcom/sm8150-hdk.dts | 264 |
1 files changed, 254 insertions, 10 deletions
diff --git a/arch/arm64/boot/dts/qcom/sm8150-hdk.dts b/arch/arm64/boot/dts/qcom/sm8150-hdk.dts index bb161b536da4..de670b407ef1 100644 --- a/arch/arm64/boot/dts/qcom/sm8150-hdk.dts +++ b/arch/arm64/boot/dts/qcom/sm8150-hdk.dts @@ -7,6 +7,7 @@ #include <dt-bindings/regulator/qcom,rpmh-regulator.h> #include <dt-bindings/gpio/gpio.h> +#include <dt-bindings/usb/pd.h> #include "sm8150.dtsi" #include "pm8150.dtsi" #include "pm8150b.dtsi" @@ -54,6 +55,17 @@ gpios = <&pm8150_gpios 6 GPIO_ACTIVE_LOW>; }; }; + + hdmi-out { + compatible = "hdmi-connector"; + type = "a"; + + port { + hdmi_con: endpoint { + remote-endpoint = <<9611_out>; + }; + }; + }; }; &apps_rsc { @@ -127,8 +139,6 @@ vdda_sp_sensor: vdda_ufs_2ln_core_1: vdda_ufs_2ln_core_2: - vdda_usb_ss_dp_core_1: - vdda_usb_ss_dp_core_2: vdda_qlink_lv: vdda_qlink_lv_ck: vreg_l5a_0p875: ldo5 { @@ -210,6 +220,12 @@ regulator-max-microvolt = <3008000>; regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>; }; + + vreg_l18a_0p8: ldo18 { + regulator-min-microvolt = <880000>; + regulator-max-microvolt = <880000>; + regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>; + }; }; regulators-1 { @@ -359,15 +375,210 @@ status = "okay"; }; +&gpi_dma0 { + status = "okay"; +}; + +&gpi_dma1 { + status = "okay"; +}; + &gpu { - /* - * NOTE: "amd,imageon" makes Adreno start in headless mode, remove it - * after display support is added on this board. - */ - compatible = "qcom,adreno-640.1", "qcom,adreno", "amd,imageon"; status = "okay"; }; +&i2c4 { + clock-frequency = <100000>; + + status = "okay"; + + typec-mux@42 { + compatible = "fcs,fsa4480"; + reg = <0x42>; + + interrupts-extended = <&tlmm 152 IRQ_TYPE_LEVEL_LOW>; + + vcc-supply = <&vreg_bob>; + mode-switch; + orientation-switch; + + port { + fsa4480_sbu_mux: endpoint { + remote-endpoint = <&pm8150b_typec_sbu_out>; + }; + }; + }; +}; + +&i2c9 { + status = "okay"; + clock-frequency = <400000>; + + lt9611_codec: hdmi-bridge@3b { + compatible = "lontium,lt9611"; + reg = <0x3b>; + #sound-dai-cells = <1>; + + interrupts-extended = <&tlmm 9 IRQ_TYPE_EDGE_FALLING>; + + reset-gpios = <&tlmm 7 GPIO_ACTIVE_HIGH>; + + vdd-supply = <&vreg_s4a_1p8>; + vcc-supply = <&vreg_bob>; + + pinctrl-names = "default"; + pinctrl-0 = <<9611_irq_pin>; + + ports { + #address-cells = <1>; + #size-cells = <0>; + + port@0 { + reg = <0>; + + lt9611_a: endpoint { + remote-endpoint = <&mdss_dsi0_out>; + }; + }; + + port@1 { + reg = <1>; + + lt9611_b: endpoint { + remote-endpoint = <&mdss_dsi1_out>; + }; + }; + + port@2 { + reg = <2>; + + lt9611_out: endpoint { + remote-endpoint = <&hdmi_con>; + }; + }; + }; + }; +}; + +&mdss { + status = "okay"; +}; + +&mdss_dp { + status = "okay"; +}; + +&mdss_dp_out { + data-lanes = <0 1>; + remote-endpoint = <&usb_1_qmpphy_dp_in>; +}; + +&mdss_dsi0 { + status = "okay"; + vdda-supply = <&vreg_l3c_1p2>; + + qcom,dual-dsi-mode; + qcom,master-dsi; + + ports { + port@1 { + endpoint { + remote-endpoint = <<9611_a>; + data-lanes = <0 1 2 3>; + }; + }; + }; +}; + +&mdss_dsi0_phy { + status = "okay"; + vdds-supply = <&vreg_l5a_0p875>; +}; + +&mdss_dsi1 { + vdda-supply = <&vreg_l3c_1p2>; + + qcom,dual-dsi-mode; + + /* DSI1 is slave, so use DSI0 clocks */ + assigned-clock-parents = <&mdss_dsi0_phy 0>, <&mdss_dsi0_phy 1>; + + status = "okay"; + + ports { + port@1 { + endpoint { + remote-endpoint = <<9611_b>; + data-lanes = <0 1 2 3>; + }; + }; + }; +}; + +&mdss_dsi1_phy { + vdds-supply = <&vreg_l5a_0p875>; + status = "okay"; +}; + +&pm8150b_vbus { + regulator-min-microamp = <500000>; + regulator-max-microamp = <3000000>; + status = "okay"; +}; + +&pm8150b_typec { + status = "okay"; + + vdd-pdphy-supply = <&vreg_l2a_3p1>; + + connector { + compatible = "usb-c-connector"; + + power-role = "source"; + data-role = "dual"; + self-powered; + + source-pdos = <PDO_FIXED(5000, 3000, + PDO_FIXED_DUAL_ROLE | + PDO_FIXED_USB_COMM | + PDO_FIXED_DATA_SWAP)>; + + altmodes { + displayport { + svid = /bits/ 16 <0xff01>; + vdo = <0x00001c46>; + }; + }; + + ports { + #address-cells = <1>; + #size-cells = <0>; + + port@0 { + reg = <0>; + pm8150b_role_switch_in: endpoint { + remote-endpoint = <&usb_1_dwc3_hs>; + }; + }; + + port@1 { + reg = <1>; + pm8150b_typec_mux_in: endpoint { + remote-endpoint = <&usb_1_qmpphy_out>; + }; + }; + + port@2 { + reg = <2>; + + pm8150b_typec_sbu_out: endpoint { + remote-endpoint = <&fsa4480_sbu_mux>; + }; + }; + }; + }; +}; + &pon_pwrkey { status = "okay"; }; @@ -378,6 +589,10 @@ linux,code = <KEY_VOLUMEDOWN>; }; +&qupv3_id_0 { + status = "okay"; +}; + &qupv3_id_1 { status = "okay"; }; @@ -402,6 +617,13 @@ &tlmm { gpio-reserved-ranges = <0 4>, <126 4>; + + lt9611_irq_pin: lt9611-irq-state { + pins = "gpio9"; + function = "gpio"; + bias-disable; + }; + }; &uart2 { @@ -445,13 +667,26 @@ &usb_1_qmpphy { status = "okay"; vdda-phy-supply = <&vreg_l3c_1p2>; - vdda-pll-supply = <&vdda_usb_ss_dp_core_1>; + vdda-pll-supply = <&vreg_l18a_0p8>; + orientation-switch; +}; + +&usb_1_qmpphy_dp_in { + remote-endpoint = <&mdss_dp_out>; +}; + +&usb_1_qmpphy_out { + remote-endpoint = <&pm8150b_typec_mux_in>; +}; + +&usb_1_qmpphy_usb_ss_in { + remote-endpoint = <&usb_1_dwc3_ss>; }; &usb_2_qmpphy { status = "okay"; vdda-phy-supply = <&vreg_l3c_1p2>; - vdda-pll-supply = <&vdda_usb_ss_dp_core_1>; + vdda-pll-supply = <&vreg_l5a_0p875>; }; &usb_1 { @@ -463,7 +698,16 @@ }; &usb_1_dwc3 { - dr_mode = "peripheral"; + dr_mode = "otg"; + usb-role-switch; +}; + +&usb_1_dwc3_hs { + remote-endpoint = <&pm8150b_role_switch_in>; +}; + +&usb_1_dwc3_ss { + remote-endpoint = <&usb_1_qmpphy_usb_ss_in>; }; &usb_2_dwc3 { |