diff options
Diffstat (limited to 'Documentation/devicetree/bindings/iio/adc/adi,ad7768-1.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/iio/adc/adi,ad7768-1.txt | 41 |
1 files changed, 41 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/iio/adc/adi,ad7768-1.txt b/Documentation/devicetree/bindings/iio/adc/adi,ad7768-1.txt new file mode 100644 index 000000000000..9f5b88cf680d --- /dev/null +++ b/Documentation/devicetree/bindings/iio/adc/adi,ad7768-1.txt @@ -0,0 +1,41 @@ +Analog Devices AD7768-1 ADC device driver + +Required properties for the AD7768-1: + +- compatible: Must be "adi,ad7768-1" +- reg: SPI chip select number for the device +- spi-max-frequency: Max SPI frequency to use + see: Documentation/devicetree/bindings/spi/spi-bus.txt +- clocks: phandle to the master clock (mclk) + see: Documentation/devicetree/bindings/clock/clock-bindings.txt +- clock-names: Must be "mclk". +- interrupts: IRQ line for the ADC + see: Documentation/devicetree/bindings/interrupt-controller/interrupts.txt +- vref-supply: vref supply can be used as reference for conversion +- adi,sync-in-gpios: must be the device tree identifier of the SYNC-IN pin. Enables + synchronization of multiple devices that require simultaneous sampling. + A pulse is always required if the configuration is changed in any way, for example + if the filter decimation rate changes. As the line is active low, it should + be marked GPIO_ACTIVE_LOW. + +Optional properties: + + - reset-gpios : GPIO spec for the RESET pin. If specified, it will be asserted during + driver probe. As the line is active low, it should be marked GPIO_ACTIVE_LOW. + +Example: + + adc@0 { + compatible = "adi,ad7768-1"; + reg = <0>; + spi-max-frequency = <2000000>; + spi-cpol; + spi-cpha; + vref-supply = <&adc_vref>; + interrupts = <25 IRQ_TYPE_EDGE_RISING>; + interrupt-parent = <&gpio>; + adi,sync-in-gpios = <&gpio 22 GPIO_ACTIVE_LOW>; + reset-gpios = <&gpio 27 GPIO_ACTIVE_LOW>; + clocks = <&ad7768_mclk>; + clock-names = "mclk"; + }; |