summaryrefslogtreecommitdiffstats
path: root/drivers/net/phy/bcm-cygnus.c
blob: 9ccf28b0a04d1aa253d03826dc65f2e4cb77158e (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
// SPDX-License-Identifier: GPL-2.0
/*
 * Copyright (C) 2015 Broadcom Corporation
 */

/* Broadcom Cygnus SoC internal transceivers support. */
#include "bcm-phy-lib.h"
#include <linux/brcmphy.h>
#include <linux/module.h>
#include <linux/netdevice.h>
#include <linux/phy.h>

struct bcm_omega_phy_priv {
	u64	*stats;
};

/* Broadcom Cygnus Phy specific registers */
#define MII_BCM_CYGNUS_AFE_VDAC_ICTRL_0  0x91E5 /* VDAL Control register */

static int bcm_cygnus_afe_config(struct phy_device *phydev)
{
	int rc;

	/* ensure smdspclk is enabled */
	rc = phy_write(phydev, MII_BCM54XX_AUX_CTL, 0x0c30);
	if (rc < 0)
		return rc;

	/* AFE_VDAC_ICTRL_0 bit 7:4 Iq=1100 for 1g 10bt, normal modes */
	rc = bcm_phy_write_misc(phydev, 0x39, 0x01, 0xA7C8);
	if (rc < 0)
		return rc;

	/* AFE_HPF_TRIM_OTHERS bit11=1, short cascode enable for all modes*/
	rc = bcm_phy_write_misc(phydev, 0x3A, 0x00, 0x0803);
	if (rc < 0)
		return rc;

	/* AFE_TX_CONFIG_1 bit 7:4 Iq=1100 for test modes */
	rc = bcm_phy_write_misc(phydev, 0x3A, 0x01, 0xA740);
	if (rc < 0)
		return rc;

	/* AFE TEMPSEN_OTHERS rcal_HT, rcal_LT 10000 */
	rc = bcm_phy_write_misc(phydev, 0x3A, 0x03, 0x8400);
	if (rc < 0)
		return rc;

	/* AFE_FUTURE_RSV bit 2:0 rccal <2:0>=100 */
	rc = bcm_phy_write_misc(phydev, 0x3B, 0x00, 0x0004);
	if (rc < 0)
		return rc;

	/* Adjust bias current trim to overcome digital offSet */
	rc = phy_write(phydev, MII_BRCM_CORE_BASE1E, 0x02);
	if (rc < 0)
		return rc;

	/* make rcal=100, since rdb default is 000 */
	rc = bcm_phy_write_exp_sel(phydev, MII_BRCM_CORE_EXPB1, 0x10);
	if (rc < 0)
		return rc;

	/* CORE_EXPB0, Reset R_CAL/RC_CAL Engine */
	rc = bcm_phy_write_exp_sel(phydev, MII_BRCM_CORE_EXPB0, 0x10);
	if (rc < 0)
		return rc;

	/* CORE_EXPB0, Disable Reset R_CAL/RC_CAL Engine */
	rc = bcm_phy_write_exp_sel(phydev, MII_BRCM_CORE_EXPB0, 0x00);

	return 0;
}

static int bcm_cygnus_config_init(struct phy_device *phydev)
{
	int reg, rc;

	reg = phy_read(phydev, MII_BCM54XX_ECR);
	if (reg < 0)
		return reg;

	/* Mask interrupts globally. */
	reg |= MII_BCM54XX_ECR_IM;
	rc = phy_write(phydev, MII_BCM54XX_ECR, reg);
	if (rc)
		return rc;

	/* Unmask events of interest */
	reg = ~(MII_BCM54XX_INT_DUPLEX |
		MII_BCM54XX_INT_SPEED |
		MII_BCM54XX_INT_LINK);
	rc = phy_write(phydev, MII_BCM54XX_IMR, reg);
	if (rc)
		return rc;

	/* Apply AFE settings for the PHY */
	rc = bcm_cygnus_afe_config(phydev);
	if (rc)
		return rc;

	/* Advertise EEE */
	rc = bcm_phy_set_eee(phydev, true);
	if (rc)
		return rc;

	/* Enable APD */
	return bcm_phy_enable_apd(phydev, false);
}

static int bcm_cygnus_resume(struct phy_device *phydev)
{
	int rc;

	genphy_resume(phydev);

	/* Re-initialize the PHY to apply AFE work-arounds and
	 * configurations when coming out of suspend.
	 */
	rc = bcm_cygnus_config_init(phydev);
	if (rc)
		return rc;

	/* restart auto negotiation with the new settings */
	return genphy_config_aneg(phydev);
}

static int bcm_omega_config_init(struct phy_device *phydev)
{
	u8 count, rev;
	int ret = 0;

	rev = phydev->phy_id & ~phydev->drv->phy_id_mask;

	pr_info_once("%s: %s PHY revision: 0x%02x\n",
		     phydev_name(phydev), phydev->drv->name, rev);

	/* Dummy read to a register to workaround an issue upon reset where the
	 * internal inverter may not allow the first MDIO transaction to pass
	 * the MDIO management controller and make us return 0xffff for such
	 * reads.
	 */
	phy_read(phydev, MII_BMSR);

	switch (rev) {
	case 0x00:
		ret = bcm_phy_28nm_a0b0_afe_config_init(phydev);
		break;
	default:
		break;
	}

	if (ret)
		return ret;

	ret = bcm_phy_downshift_get(phydev, &count);
	if (ret)
		return ret;

	/* Only enable EEE if Wirespeed/downshift is disabled */
	ret = bcm_phy_set_eee(phydev, count == DOWNSHIFT_DEV_DISABLE);
	if (ret)
		return ret;

	return bcm_phy_enable_apd(phydev, true);
}

static int bcm_omega_resume(struct phy_device *phydev)
{
	int ret;

	/* Re-apply workarounds coming out suspend/resume */
	ret = bcm_omega_config_init(phydev);
	if (ret)
		return ret;

	/* 28nm Gigabit PHYs come out of reset without any half-duplex
	 * or "hub" compliant advertised mode, fix that. This does not
	 * cause any problems with the PHY library since genphy_config_aneg()
	 * gracefully handles auto-negotiated and forced modes.
	 */
	return genphy_config_aneg(phydev);
}

static int bcm_omega_get_tunable(struct phy_device *phydev,
				 struct ethtool_tunable *tuna, void *data)
{
	switch (tuna->id) {
	case ETHTOOL_PHY_DOWNSHIFT:
		return bcm_phy_downshift_get(phydev, (u8 *)data);
	default:
		return -EOPNOTSUPP;
	}
}

static int bcm_omega_set_tunable(struct phy_device *phydev,
				 struct ethtool_tunable *tuna,
				 const void *data)
{
	u8 count = *(u8 *)data;
	int ret;

	switch (tuna->id) {
	case ETHTOOL_PHY_DOWNSHIFT:
		ret = bcm_phy_downshift_set(phydev, count);
		break;
	default:
		return -EOPNOTSUPP;
	}

	if (ret)
		return ret;

	/* Disable EEE advertisement since this prevents the PHY
	 * from successfully linking up, trigger auto-negotiation restart
	 * to let the MAC decide what to do.
	 */
	ret = bcm_phy_set_eee(phydev, count == DOWNSHIFT_DEV_DISABLE);
	if (ret)
		return ret;

	return genphy_restart_aneg(phydev);
}

static void bcm_omega_get_phy_stats(struct phy_device *phydev,
				    struct ethtool_stats *stats, u64 *data)
{
	struct bcm_omega_phy_priv *priv = phydev->priv;

	bcm_phy_get_stats(phydev, priv->stats, stats, data);
}

static int bcm_omega_probe(struct phy_device *phydev)
{
	struct bcm_omega_phy_priv *priv;

	priv = devm_kzalloc(&phydev->mdio.dev, sizeof(*priv), GFP_KERNEL);
	if (!priv)
		return -ENOMEM;

	phydev->priv = priv;

	priv->stats = devm_kcalloc(&phydev->mdio.dev,
				   bcm_phy_get_sset_count(phydev), sizeof(u64),
				   GFP_KERNEL);
	if (!priv->stats)
		return -ENOMEM;

	return 0;
}

static struct phy_driver bcm_cygnus_phy_driver[] = {
{
	.phy_id        = PHY_ID_BCM_CYGNUS,
	.phy_id_mask   = 0xfffffff0,
	.name          = "Broadcom Cygnus PHY",
	/* PHY_GBIT_FEATURES */
	.config_init   = bcm_cygnus_config_init,
	.ack_interrupt = bcm_phy_ack_intr,
	.config_intr   = bcm_phy_config_intr,
	.suspend       = genphy_suspend,
	.resume        = bcm_cygnus_resume,
}, {
	.phy_id		= PHY_ID_BCM_OMEGA,
	.phy_id_mask	= 0xfffffff0,
	.name		= "Broadcom Omega Combo GPHY",
	/* PHY_GBIT_FEATURES */
	.flags		= PHY_IS_INTERNAL,
	.config_init	= bcm_omega_config_init,
	.suspend	= genphy_suspend,
	.resume		= bcm_omega_resume,
	.get_tunable	= bcm_omega_get_tunable,
	.set_tunable	= bcm_omega_set_tunable,
	.get_sset_count	= bcm_phy_get_sset_count,
	.get_strings	= bcm_phy_get_strings,
	.get_stats	= bcm_omega_get_phy_stats,
	.probe		= bcm_omega_probe,
}
};

static struct mdio_device_id __maybe_unused bcm_cygnus_phy_tbl[] = {
	{ PHY_ID_BCM_CYGNUS, 0xfffffff0, },
	{ PHY_ID_BCM_OMEGA, 0xfffffff0, },
	{ }
};
MODULE_DEVICE_TABLE(mdio, bcm_cygnus_phy_tbl);

module_phy_driver(bcm_cygnus_phy_driver);

MODULE_DESCRIPTION("Broadcom Cygnus internal PHY driver");
MODULE_LICENSE("GPL v2");
MODULE_AUTHOR("Broadcom Corporation");