diff options
Diffstat (limited to 'drivers/input/keyboard/atkbd.c')
-rw-r--r-- | drivers/input/keyboard/atkbd.c | 49 |
1 files changed, 46 insertions, 3 deletions
diff --git a/drivers/input/keyboard/atkbd.c b/drivers/input/keyboard/atkbd.c index 7e3eae54c192..cb7f9b46ce65 100644 --- a/drivers/input/keyboard/atkbd.c +++ b/drivers/input/keyboard/atkbd.c @@ -715,6 +715,44 @@ static void atkbd_deactivate(struct atkbd *atkbd) ps2dev->serio->phys); } +#ifdef CONFIG_X86 +static bool atkbd_is_portable_device(void) +{ + static const char * const chassis_types[] = { + "8", /* Portable */ + "9", /* Laptop */ + "10", /* Notebook */ + "14", /* Sub-Notebook */ + "31", /* Convertible */ + "32", /* Detachable */ + }; + int i; + + for (i = 0; i < ARRAY_SIZE(chassis_types); i++) + if (dmi_match(DMI_CHASSIS_TYPE, chassis_types[i])) + return true; + + return false; +} + +/* + * On many modern laptops ATKBD_CMD_GETID may cause problems, on these laptops + * the controller is always in translated mode. In this mode mice/touchpads will + * not work. So in this case simply assume a keyboard is connected to avoid + * confusing some laptop keyboards. + * + * Skipping ATKBD_CMD_GETID ends up using a fake keyboard id. Using the standard + * 0xab83 id is ok in translated mode, only atkbd_select_set() checks atkbd->id + * and in translated mode that is a no-op. + */ +static bool atkbd_skip_getid(struct atkbd *atkbd) +{ + return atkbd->translated && atkbd_is_portable_device(); +} +#else +static inline bool atkbd_skip_getid(struct atkbd *atkbd) { return false; } +#endif + /* * atkbd_probe() probes for an AT keyboard on a serio port. */ @@ -736,6 +774,11 @@ static int atkbd_probe(struct atkbd *atkbd) "keyboard reset failed on %s\n", ps2dev->serio->phys); + if (atkbd_skip_getid(atkbd)) { + atkbd->id = 0xab83; + return 0; + } + /* * Then we check the keyboard ID. We should get 0xab83 under normal conditions. * Some keyboards report different values, but the first byte is always 0xab or @@ -747,9 +790,9 @@ static int atkbd_probe(struct atkbd *atkbd) if (ps2_command(ps2dev, param, ATKBD_CMD_GETID)) { /* - * If the get ID command failed, we check if we can at least set the LEDs on - * the keyboard. This should work on every keyboard out there. It also turns - * the LEDs off, which we want anyway. + * If the get ID command failed, we check if we can at least set + * the LEDs on the keyboard. This should work on every keyboard out there. + * It also turns the LEDs off, which we want anyway. */ param[0] = 0; if (ps2_command(ps2dev, param, ATKBD_CMD_SETLEDS)) |