1 files changed, 62 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/media/xilinx/xlnx,v-demosaic.txt b/Documentation/devicetree/bindings/media/xilinx/xlnx,v-demosaic.txt
new file mode 100644
index 000000000000..9b3aff413e0e
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/xilinx/xlnx,v-demosaic.txt
@@ -0,0 +1,62 @@
+Xilinx Video Demosaic IP
+-----------------------------
+The Xilinx Video Demosaic IP is used to interface to a Bayer video source.
+
+The driver set default Sink Pad media bus format to RGGB.
+The IP and driver only support RGB as its Source Pad media format.
+
+Required properties:
+
+- compatible: Must be "xlnx,v-demosaic".
+
+- reg: Physical base address and length of the registers set for the device.
+
+- clocks: Reference to the AXI Streaming clock feeding the Demosaic ap_clk.
+
+- xlnx,max-height: Maximum number of lines. Valid range is 64 to 4320.
+
+- xlnx,max-width: Maximum number of pixels in a line. Valid range is 64 to 8192.
+
+- reset-gpios: Specifier for GPIO that asserts Demosaic IP (AP_RST_N) reset.
+
+- ports: Video ports, using the DT bindings defined in ../video-interfaces.txt.
+
+Required port properties:
+
+- reg: This value represents the media pad of the V4L2 sub-device.
+  A Sink Pad is represented by reg = <0>
+  A Source Pad is represented by reg = <1>
+
+- xlnx,video-width: Video width as defined in video.txt
+
+Example:
+	demosaic_1: demosaic@a00b0000 {
+		compatible = "xlnx,v-demosaic";
+		reg = <0x0 0xa00b0000 0x0 0x10000>;
+		clocks = <&vid_stream_clk>;
+		reset-gpios = <&gpio 87 1>;
+		xlnx,max-width = <3840>;
+		xlnx,max-height = <2160>;
+		ports {
+			#address-cells = <1>;
+			#size-cells = <0>;
+
+			port@0 {
+				reg = <0>;
+				xlnx,video-width = <8>;
+
+				demosaic_in: endpoint {
+					remote-endpoint = <&tpg_out>;
+				};
+			};
+
+			port@1 {
+				reg = <1>;
+				xlnx,video-width = <8>;
+
+				demosaic_out: endpoint {
+					remote-endpoint = <&gamma_in>;
+				};
+			};
+		};
+	};