summaryrefslogtreecommitdiffstats
path: root/Documentation/leds/ledtrig-oneshot.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/leds/ledtrig-oneshot.txt')
-rw-r--r--Documentation/leds/ledtrig-oneshot.txt59
1 files changed, 59 insertions, 0 deletions
diff --git a/Documentation/leds/ledtrig-oneshot.txt b/Documentation/leds/ledtrig-oneshot.txt
new file mode 100644
index 000000000000..07cd1fa41a3a
--- /dev/null
+++ b/Documentation/leds/ledtrig-oneshot.txt
@@ -0,0 +1,59 @@
+One-shot LED Trigger
+====================
+
+This is a LED trigger useful for signaling the user of an event where there are
+no clear trap points to put standard led-on and led-off settings. Using this
+trigger, the application needs only to signal the trigger when an event has
+happened, than the trigger turns the LED on and than keeps it off for a
+specified amount of time.
+
+This trigger is meant to be usable both for sporadic and dense events. In the
+first case, the trigger produces a clear single controlled blink for each
+event, while in the latter it keeps blinking at constant rate, as to signal
+that the events are arriving continuously.
+
+A one-shot LED only stays in a constant state when there are no events. An
+additional "invert" property specifies if the LED has to stay off (normal) or
+on (inverted) when not rearmed.
+
+The trigger can be activated from user space on led class devices as shown
+below:
+
+ echo oneshot > trigger
+
+This adds the following sysfs attributes to the LED:
+
+ delay_on - specifies for how many milliseconds the LED has to stay at
+ LED_FULL brightness after it has been armed.
+ Default to 100 ms.
+
+ delay_off - specifies for how many milliseconds the LED has to stay at
+ LED_OFF brightness after it has been armed.
+ Default to 100 ms.
+
+ invert - reverse the blink logic. If set to 0 (default) blink on for delay_on
+ ms, then blink off for delay_off ms, leaving the LED normally off. If
+ set to 1, blink off for delay_off ms, then blink on for delay_on ms,
+ leaving the LED normally on.
+ Setting this value also immediately change the LED state.
+
+ shot - write any non-empty string to signal an events, this starts a blink
+ sequence if not already running.
+
+Example use-case: network devices, initialization:
+
+ echo oneshot > trigger # set trigger for this led
+ echo 33 > delay_on # blink at 1 / (33 + 33) Hz on continuous traffic
+ echo 33 > delay_off
+
+interface goes up:
+
+ echo 1 > invert # set led as normally-on, turn the led on
+
+packet received/transmitted:
+
+ echo 1 > shot # led starts blinking, ignored if already blinking
+
+interface goes down
+
+ echo 0 > invert # set led as normally-off, turn the led off