1 files changed, 0 insertions, 62 deletions
diff --git a/Documentation/devicetree/bindings/power/supply/bq24257.txt b/Documentation/devicetree/bindings/power/supply/bq24257.txt
deleted file mode 100644
index f8f5a1685bb9..000000000000
--- a/Documentation/devicetree/bindings/power/supply/bq24257.txt
+++ /dev/null
@@ -1,62 +0,0 @@
-Binding for TI bq24250/bq24251/bq24257 Li-Ion Charger
-
-Required properties:
-- compatible: Should contain one of the following:
- * "ti,bq24250"
- * "ti,bq24251"
- * "ti,bq24257"
-- reg: integer, i2c address of the device.
-- interrupts: Interrupt mapping for GPIO IRQ (configure for both edges). Use in
-    conjunction with "interrupt-parent".
-- ti,battery-regulation-voltage: integer, maximum charging voltage in uV.
-- ti,charge-current: integer, maximum charging current in uA.
-- ti,termination-current: integer, charge will be terminated when current in
-    constant-voltage phase drops below this value (in uA).
-
-Optional properties:
-- pg-gpios: GPIO used for connecting the bq2425x device PG (Power Good) pin.
-    This pin is not available on all devices however it should be used if
-    possible as this is the recommended way to obtain the charger's input PG
-    state. If this pin is not specified a software-based approach for PG
-    detection is used.
-- ti,current-limit: The maximum current to be drawn from the charger's input
-    (in uA). If this property is not specified, the input limit current is
-    set automatically using USB D+/D- signal based charger type detection.
-    If the hardware does not support the D+/D- based detection, a default
-    of 500,000 is used (=500mA) instead.
-- ti,ovp-voltage: Configures the over voltage protection voltage (in uV). If
-    not specified a default of 6,5000,000 (=6.5V) is used.
-- ti,in-dpm-voltage: Configures the threshold input voltage for the dynamic
-    power path management (in uV). If not specified a default of 4,360,000
-    (=4.36V) is used.
-
-Example:
-
-bq24257 {
-	compatible = "ti,bq24257";
-	reg = <0x6a>;
-	interrupt-parent = <&gpio1>;
-	interrupts = <16 IRQ_TYPE_EDGE_BOTH>;
-
-	pg-gpios = <&gpio1 28 GPIO_ACTIVE_HIGH>;
-
-	ti,battery-regulation-voltage = <4200000>;
-	ti,charge-current = <1000000>;
-	ti,termination-current = <50000>;
-};
-
-Example:
-
-bq24250 {
-	compatible = "ti,bq24250";
-	reg = <0x6a>;
-	interrupt-parent = <&gpio1>;
-	interrupts = <16 IRQ_TYPE_EDGE_BOTH>;
-
-	ti,battery-regulation-voltage = <4200000>;
-	ti,charge-current = <500000>;
-	ti,termination-current = <50000>;
-	ti,current-limit = <900000>;
-	ti,ovp-voltage = <9500000>;
-	ti,in-dpm-voltage = <4440000>;
-};