From 34d88746a9aa4aedb67e32579e559cbeb91de20f Mon Sep 17 00:00:00 2001 From: Robert Nelson Date: Thu, 23 Sep 2010 18:22:48 -0700 Subject: [PATCH 02/10] omap: Beagle: only Cx boards use pin 23 for write protect system_rev comes from u-boot and is a constant 0x20, so Bx boards also fall in this 'if' and will get setup with the wrong gpio_wp pin. Switch to using the Beagle revision routine to correcly set pin 23 only for C1/2/3 and C4 Boards. Bx boards will then use the correct default pin setting. Signed-off-by: Robert Nelson Acked-by: Jarkko Nikula Signed-off-by: Tony Lindgren --- arch/arm/mach-omap2/board-omap3beagle.c | 3 ++- 1 files changed, 2 insertions(+), 1 deletions(-) diff --git a/arch/arm/mach-omap2/board-omap3beagle.c b/arch/arm/mach-omap2/board-omap3beagle.c index 7ca2b3b..beb877c 100644 --- a/arch/arm/mach-omap2/board-omap3beagle.c +++ b/arch/arm/mach-omap2/board-omap3beagle.c @@ -444,7 +444,8 @@ static struct gpio_led gpio_leds[]; static int beagle_twl_gpio_setup(struct device *dev, unsigned gpio, unsigned ngpio) { - if (system_rev >= 0x20 && system_rev <= 0x34301000) { + if ((omap3_beagle_get_rev() == OMAP3BEAGLE_BOARD_C1_3) || + (omap3_beagle_get_rev() == OMAP3BEAGLE_BOARD_C4)) { omap_mux_init_gpio(23, OMAP_PIN_INPUT); mmc[0].gpio_wp = 23; } else { -- 1.6.6.1