blob: ece6d483f84e6a083fbc0346a688d513dedbd117 (plain
# 3. Deploying an image to the target
After [building an image](BUILD.md), we can deploy it to the target
using a USB Flash Drive or a CD/DVD. The built images can be found in
the `<build-dir>/tmp/deploy/images/<machine-name>` directory to
which we will refer to as the **"Image Deploy Directory"** in this doc.
Change these placeholders in the following instructions according to
the selected BSP and the image built in [section 2 - build](BUILD.md):
Change directory to the Image Deploy Directory:
This directory contains `.wic` and `.iso` images for USB and CD/DVD
respectively. Follow the instructions below to make a bootable
USB Flash Drive or a CD/DVD by writing/burning the image to it:
### 3.1a. Deploy using a USB Flash Drive
We can use **bmaptool** (from *bmap-tools* package) or **dd** to write
the `<image-name>-<machine-name>.wic` image located in the
Image Deploy Directory to a USB Flash Drive:
##### Using bmaptool *(recommended)*
sudo bmaptool copy <image-name>-<machine-name>.wic /dev/<dev-node>
##### Using dd
sudo dd if=<image-name>-<machine-name>.wic of=/dev/<dev-node> status=progress
###### where `<dev-node>` is to be replaced with the device node of the USB Flash Drive.
###### (e.g. `sda`, `sdb` or `sdc` etc.)
### 3.1b. Deploy using a CD/DVD
You may use any CD/DVD burning tool to burn the
`<image-name>-<machine-name>.iso` image located in the
Image Deploy Directory onto a writable CD/DVD.
### 3.2. Booting the target
Insert the bootable USB or CD/DVD (created in above steps) into the
target machine and power ON the machine.
You may need to press `Esc` key right after pressing the power ON
button to enter the BIOS setup and set the boot device priority/order
to boot from the inserted USB or CD/DVD.
The grub boot menu should appear at this point where you will see
options to `boot` or `install` this image:
* Select the `boot` option to boot up the target machine.
* Select the `install` option to install the image onto the target
machine's hard drive. Follow the instructions there to complete the
installation process, and reboot the machine and boot from the
hard drive you selected during the installation process.
You will be presented with a console (serial or graphical) or a
graphical user interface depending on the image and the target machine.
#### What's next
You can also [customize the image](CUSTOMIZE.md) by enabling/disabling
certain configurable features. Make sure to
[re-build the image](BUILD.md) before deploying the customized build.