| Age | Commit message (Collapse) | Author |
|---|
|
Add SPDX identifiers to files under sti directory
Signed-off-by: Benjamin Gaignard <benjamin.gaignard@st.com>
Acked-by: Vincent Abriou <vincent.abriou@st.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20171206112947.9569-2-benjamin.gaignard@st.com
|
|
Implement the CEC notifier support to allow CEC drivers to
be informed when there is a new physical address.
Signed-off-by: Benjamin Gaignard <benjamin.gaignard@linaro.org>
Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Acked-by: Daniel Vetter <daniel.vetter@ffwll.ch>
Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com>
|
|
Remove the hdmi_mode_property and use drm_detect_hdmi_monitor function
to check whether the connected monitor is HDMI capable or DVI only.
Signed-off-by: Vincent Abriou <vincent.abriou@st.com>
|
|
Add the interface needed by audio hdmi-codec driver.
Signed-off-by: Arnaud Pouliquen <arnaud.pouliquen@st.com>
|
|
Signed-off-by: Vincent Abriou <vincent.abriou@st.com>
Reviewed-by: Benjamin Gaignard <benjamin.gaignard@linaro.org>
|
|
Configures the framer of the HDMI connection.
By default starts in HDMI mode and can be swtich to DVI.
Signed-off-by: Vincent Abriou <vincent.abriou@st.com>
Reviewed-by: Benjamin Gaignard <benjamin.gaignard@linaro.org>
|
|
Make the value of the colorspace of the HDMI infoframe configurable.
HDMI colorspace could be: RGB, YUV422 or YUV444
Signed-off-by: Vincent Abriou <vincent.abriou@st.com>
Reviewed-by: Benjamin Gaignard <benjamin.gaignard@linaro.org>
|
|
gpio used for HDMI hot plug detection is useless,
HDMI_STI register contains an hot plug detection status bit.
Fix binding documentation.
Signed-off-by: Benjamin Gaignard <benjamin.gaignard@linaro.org>
|
|
Depending of the board configuration i2c for ddc could change,
this patch allow to use a phandle to specify which i2c controller to use.
Signed-off-by: Benjamin Gaignard <benjamin.gaignard@linaro.org>
|
|
Add driver for HDMI output.
HDMI PHY registers are mixed into HDMI device registers
and their is only one IRQ for all this hardware block.
That is why PHYs aren't using phy framework but only a
thin hdmi_phy_ops structure with start and stop functions.
HDMI driver is mapped on drm_bridge and drm_connector structures.
Signed-off-by: Benjamin Gaignard <benjamin.gaignard@linaro.org>
Reviewed-by: Rob Clark <robdclark@gmail.com>
|
Benjamin Gaignard
Vincent Abriou
Arnaud Pouliquen