aboutsummaryrefslogtreecommitdiffstats
path: root/arch/arm/boot/dts/tegra30-apalis-v1.1-eval.dts
AgeCommit message (Collapse)Author
2020-06-25ARM: tegra: Use proper tuple notationThierry Reding
Tuple boundaries should be marked by < and > to make it clear which cells are part of the same tuple. This also helps the json-schema based validation tooling to properly parse this data. While at it, also remove the "immovable" bit from PCI addresses. All of these addresses are in fact "movable". Cc: Marcel Ziswiler <marcel.ziswiler@toradex.com> Cc: Philippe Schenker <philippe.schenker@toradex.com> Signed-off-by: Thierry Reding <treding@nvidia.com>
2020-06-25ARM: tegra: Rename sdhci nodes to mmcThierry Reding
The new json-schema based validation tools require SD/MMC controller nodes to be named mmc. Rename all references to them. Cc: Marcel Ziswiler <marcel.ziswiler@toradex.com> Cc: Philippe Schenker <philippe.schenker@toradex.com> Signed-off-by: Thierry Reding <treding@nvidia.com>
2020-04-17ARM: tegra: Kill off "simple-panel" compatiblesRob Herring
"simple-panel" is a Linux driver and has never been an accepted upstream compatible string, so remove it. Cc: Thierry Reding <thierry.reding@gmail.com> Cc: Jonathan Hunter <jonathanh@nvidia.com> Cc: linux-tegra@vger.kernel.org Signed-off-by: Rob Herring <robh@kernel.org> Signed-off-by: Thierry Reding <treding@nvidia.com>
2018-09-26ARM: tegra: apalis_t30: support v1.1 hardware revisionMarcel Ziswiler
Support the V1.1 hardware revisions with the following change: Changed power rail for MMC1 interface to a 3.3V/1.8V switchable rail in order to be able to run UHS SD cards in ultra high speed 1.8V mode. [ 207.502011] mmc2: host does not support reading read-only switch, assuming write-enable [ 207.517011] mmc2: new ultra high speed SDR104 SDHC card at address aaaa [ 207.534190] mmcblk2: mmc2:aaaa SE32G 29.7 GiB [ 207.545096] mmcblk2: p1 root@apalis-t30:~# cat /sys/kernel/debug/mmc2/ios clock: 208000000 Hz actual clock: 204000000 Hz vdd: 21 (3.3 ~ 3.4 V) bus mode: 2 (push-pull) chip select: 0 (don't care) power mode: 2 (on) bus width: 2 (4 bits) timing spec: 6 (sd uhs SDR104) signal voltage: 1 (1.80 V) driver type: 0 (driver type B) root@apalis-t30:~# hdparm -t /dev/mmcblk2 /dev/mmcblk2: Timing buffered disk reads: 256 MB in 3.02 seconds = 84.71 MB/sec Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com> Reviewed-by: Rob Herring <robh@kernel.org> Signed-off-by: Thierry Reding <treding@nvidia.com>