diff options
Diffstat (limited to 'drivers/usb/core/hub.c')
-rw-r--r-- | drivers/usb/core/hub.c | 104 |
1 files changed, 84 insertions, 20 deletions
diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c index 1fc57c339fe6..56a0bd05aa2c 100644 --- a/drivers/usb/core/hub.c +++ b/drivers/usb/core/hub.c @@ -38,6 +38,8 @@ #define USB_VENDOR_GENESYS_LOGIC 0x05e3 #define USB_VENDOR_SMSC 0x0424 #define USB_PRODUCT_USB5534B 0x5534 +#define USB_VENDOR_CYPRESS 0x04b4 +#define USB_PRODUCT_CY7C65632 0x6570 #define HUB_QUIRK_CHECK_PORT_AUTOSUSPEND 0x01 #define HUB_QUIRK_DISABLE_AUTOSUSPEND 0x02 @@ -3496,9 +3498,6 @@ int usb_port_resume(struct usb_device *udev, pm_message_t msg) * sequence. */ status = hub_port_status(hub, port1, &portstatus, &portchange); - - /* TRSMRCY = 10 msec */ - msleep(10); } SuspendCleared: @@ -3513,6 +3512,9 @@ int usb_port_resume(struct usb_device *udev, pm_message_t msg) usb_clear_port_feature(hub->hdev, port1, USB_PORT_FEAT_C_SUSPEND); } + + /* TRSMRCY = 10 msec */ + msleep(10); } if (udev->persist_enabled) @@ -3902,6 +3904,47 @@ static int usb_set_lpm_timeout(struct usb_device *udev, } /* + * Don't allow device intiated U1/U2 if the system exit latency + one bus + * interval is greater than the minimum service interval of any active + * periodic endpoint. See USB 3.2 section 9.4.9 + */ +static bool usb_device_may_initiate_lpm(struct usb_device *udev, + enum usb3_link_state state) +{ + unsigned int sel; /* us */ + int i, j; + + if (state == USB3_LPM_U1) + sel = DIV_ROUND_UP(udev->u1_params.sel, 1000); + else if (state == USB3_LPM_U2) + sel = DIV_ROUND_UP(udev->u2_params.sel, 1000); + else + return false; + + for (i = 0; i < udev->actconfig->desc.bNumInterfaces; i++) { + struct usb_interface *intf; + struct usb_endpoint_descriptor *desc; + unsigned int interval; + + intf = udev->actconfig->interface[i]; + if (!intf) + continue; + + for (j = 0; j < intf->cur_altsetting->desc.bNumEndpoints; j++) { + desc = &intf->cur_altsetting->endpoint[j].desc; + + if (usb_endpoint_xfer_int(desc) || + usb_endpoint_xfer_isoc(desc)) { + interval = (1 << (desc->bInterval - 1)) * 125; + if (sel + 125 > interval) + return false; + } + } + } + return true; +} + +/* * Enable the hub-initiated U1/U2 idle timeouts, and enable device-initiated * U1/U2 entry. * @@ -3973,20 +4016,23 @@ static void usb_enable_link_state(struct usb_hcd *hcd, struct usb_device *udev, * U1/U2_ENABLE */ if (udev->actconfig && - usb_set_device_initiated_lpm(udev, state, true) == 0) { - if (state == USB3_LPM_U1) - udev->usb3_lpm_u1_enabled = 1; - else if (state == USB3_LPM_U2) - udev->usb3_lpm_u2_enabled = 1; - } else { - /* Don't request U1/U2 entry if the device - * cannot transition to U1/U2. - */ - usb_set_lpm_timeout(udev, state, 0); - hcd->driver->disable_usb3_lpm_timeout(hcd, udev, state); + usb_device_may_initiate_lpm(udev, state)) { + if (usb_set_device_initiated_lpm(udev, state, true)) { + /* + * Request to enable device initiated U1/U2 failed, + * better to turn off lpm in this case. + */ + usb_set_lpm_timeout(udev, state, 0); + hcd->driver->disable_usb3_lpm_timeout(hcd, udev, state); + return; + } } -} + if (state == USB3_LPM_U1) + udev->usb3_lpm_u1_enabled = 1; + else if (state == USB3_LPM_U2) + udev->usb3_lpm_u2_enabled = 1; +} /* * Disable the hub-initiated U1/U2 idle timeouts, and disable device-initiated * U1/U2 entry. @@ -4426,8 +4472,6 @@ hub_port_init(struct usb_hub *hub, struct usb_device *udev, int port1, if (oldspeed == USB_SPEED_LOW) delay = HUB_LONG_RESET_TIME; - mutex_lock(hcd->address0_mutex); - /* Reset the device; full speed may morph to high speed */ /* FIXME a USB 2.0 device may morph into SuperSpeed on reset. */ retval = hub_port_reset(hub, port1, udev, delay, false); @@ -4726,7 +4770,6 @@ fail: hub_port_disable(hub, port1, 0); update_devnum(udev, devnum); /* for disconnect processing */ } - mutex_unlock(hcd->address0_mutex); return retval; } @@ -4816,6 +4859,7 @@ static void hub_port_connect(struct usb_hub *hub, int port1, u16 portstatus, struct usb_port *port_dev = hub->ports[port1 - 1]; struct usb_device *udev = port_dev->child; static int unreliable_port = -1; + bool retry_locked; /* Disconnect any existing devices under this port */ if (udev) { @@ -4871,7 +4915,11 @@ static void hub_port_connect(struct usb_hub *hub, int port1, u16 portstatus, unit_load = 100; status = 0; + for (i = 0; i < SET_CONFIG_TRIES; i++) { + usb_lock_port(port_dev); + mutex_lock(hcd->address0_mutex); + retry_locked = true; /* reallocate for each attempt, since references * to the previous one can escape in various ways @@ -4880,6 +4928,8 @@ static void hub_port_connect(struct usb_hub *hub, int port1, u16 portstatus, if (!udev) { dev_err(&port_dev->dev, "couldn't allocate usb_device\n"); + mutex_unlock(hcd->address0_mutex); + usb_unlock_port(port_dev); goto done; } @@ -4901,12 +4951,14 @@ static void hub_port_connect(struct usb_hub *hub, int port1, u16 portstatus, } /* reset (non-USB 3.0 devices) and get descriptor */ - usb_lock_port(port_dev); status = hub_port_init(hub, udev, port1, i); - usb_unlock_port(port_dev); if (status < 0) goto loop; + mutex_unlock(hcd->address0_mutex); + usb_unlock_port(port_dev); + retry_locked = false; + if (udev->quirks & USB_QUIRK_DELAY_INIT) msleep(2000); @@ -4999,6 +5051,10 @@ loop: usb_ep0_reinit(udev); release_devnum(udev); hub_free_dev(udev); + if (retry_locked) { + mutex_unlock(hcd->address0_mutex); + usb_unlock_port(port_dev); + } usb_put_dev(udev); if ((status == -ENOTCONN) || (status == -ENOTSUPP)) break; @@ -5326,6 +5382,11 @@ static const struct usb_device_id hub_id_table[] = { .bInterfaceClass = USB_CLASS_HUB, .driver_info = HUB_QUIRK_DISABLE_AUTOSUSPEND}, { .match_flags = USB_DEVICE_ID_MATCH_VENDOR + | USB_DEVICE_ID_MATCH_PRODUCT, + .idVendor = USB_VENDOR_CYPRESS, + .idProduct = USB_PRODUCT_CY7C65632, + .driver_info = HUB_QUIRK_DISABLE_AUTOSUSPEND}, + { .match_flags = USB_DEVICE_ID_MATCH_VENDOR | USB_DEVICE_ID_MATCH_INT_CLASS, .idVendor = USB_VENDOR_GENESYS_LOGIC, .bInterfaceClass = USB_CLASS_HUB, @@ -5557,6 +5618,8 @@ static int usb_reset_and_verify_device(struct usb_device *udev) bos = udev->bos; udev->bos = NULL; + mutex_lock(hcd->address0_mutex); + for (i = 0; i < SET_CONFIG_TRIES; ++i) { /* ep0 maxpacket size may change; let the HCD know about it. @@ -5566,6 +5629,7 @@ static int usb_reset_and_verify_device(struct usb_device *udev) if (ret >= 0 || ret == -ENOTCONN || ret == -ENODEV) break; } + mutex_unlock(hcd->address0_mutex); if (ret < 0) goto re_enumerate; |