diff options
Diffstat (limited to 'arch/arc/Kconfig')
| -rw-r--r-- | arch/arc/Kconfig | 64 |
1 files changed, 12 insertions, 52 deletions
diff --git a/arch/arc/Kconfig b/arch/arc/Kconfig index a045f3086047..d750b302d5ab 100644 --- a/arch/arc/Kconfig +++ b/arch/arc/Kconfig @@ -9,16 +9,14 @@ config ARC def_bool y select ARC_TIMERS + select ARCH_HAS_DMA_COHERENT_TO_PFN select ARCH_HAS_PTE_SPECIAL select ARCH_HAS_SYNC_DMA_FOR_CPU select ARCH_HAS_SYNC_DMA_FOR_DEVICE - select ARCH_HAS_SG_CHAIN select ARCH_SUPPORTS_ATOMIC_RMW if ARC_HAS_LLSC select BUILDTIME_EXTABLE_SORT select CLONE_BACKWARDS select COMMON_CLK - select DMA_NONCOHERENT_OPS - select DMA_NONCOHERENT_MMAP select GENERIC_ATOMIC64 if !ISA_ARCV2 || !(ARC_HAS_LL64 && ARC_HAS_LLSC) select GENERIC_CLOCKEVENTS select GENERIC_FIND_FIRST_BIT @@ -26,6 +24,7 @@ config ARC select GENERIC_IRQ_SHOW select GENERIC_PCI_IOMAP select GENERIC_PENDING_IRQ if SMP + select GENERIC_SCHED_CLOCK select GENERIC_SMP_IDLE_THREAD select HAVE_ARCH_KGDB select HAVE_ARCH_TRACEHOOK @@ -37,25 +36,21 @@ config ARC select HAVE_KERNEL_LZMA select HAVE_KPROBES select HAVE_KRETPROBES - select HAVE_MEMBLOCK select HAVE_MOD_ARCH_SPECIFIC select HAVE_OPROFILE select HAVE_PERF_EVENTS select HANDLE_DOMAIN_IRQ select IRQ_DOMAIN select MODULES_USE_ELF_RELA - select NO_BOOTMEM select OF select OF_EARLY_FLATTREE select OF_RESERVED_MEM + select PCI_SYSCALL if PCI select PERF_USE_VMALLOC if ARC_CACHE_VIPT_ALIASING config ARCH_HAS_CACHE_LINE_SIZE def_bool y -config MIGHT_HAVE_PCI - bool - config TRACE_IRQFLAGS_SUPPORT def_bool y @@ -111,7 +106,7 @@ endmenu choice prompt "ARC Instruction Set" - default ISA_ARCOMPACT + default ISA_ARCV2 config ISA_ARCOMPACT bool "ARCompact ISA" @@ -178,13 +173,11 @@ endchoice config CPU_BIG_ENDIAN bool "Enable Big Endian Mode" - default n help Build kernel for Big Endian Mode of ARC CPU config SMP bool "Symmetric Multi-Processing" - default n select ARC_MCIP if ISA_ARCV2 help This enables support for systems with more than one CPU. @@ -198,7 +191,6 @@ config NR_CPUS config ARC_SMP_HALT_ON_RESET bool "Enable Halt-on-reset boot mode" - default y if ARC_UBOOT_SUPPORT help In SMP configuration cores can be configured as Halt-on-reset or they could all start at same time. For Halt-on-reset, non @@ -256,7 +248,6 @@ config ARC_CACHE_PAGES config ARC_CACHE_VIPT_ALIASING bool "Support VIPT Aliasing D$" depends on ARC_HAS_DCACHE && ISA_ARCOMPACT - default n endif #ARC_CACHE @@ -264,7 +255,6 @@ config ARC_HAS_ICCM bool "Use ICCM" help Single Cycle RAMS to store Fast Path Code - default n config ARC_ICCM_SZ int "ICCM Size in KB" @@ -275,7 +265,6 @@ config ARC_HAS_DCCM bool "Use DCCM" help Single Cycle RAMS to store Fast Path Data - default n config ARC_DCCM_SZ int "DCCM Size in KB" @@ -368,13 +357,11 @@ if ISA_ARCOMPACT config ARC_COMPACT_IRQ_LEVELS bool "Setup Timer IRQ as high Priority" - default n # if SMP, LV2 enabled ONLY if ARC implementation has LV2 re-entrancy depends on !SMP config ARC_FPU_SAVE_RESTORE bool "Enable FPU state persistence across context switch" - default n help Double Precision Floating Point unit had dedicated regs which need to be saved/restored across context-switch. @@ -419,6 +406,14 @@ config ARC_HAS_ACCL_REGS (also referred to as r58:r59). These can also be used by gcc as GPR so kernel needs to save/restore per process +config ARC_IRQ_NO_AUTOSAVE + bool "Disable hardware autosave regfile on interrupts" + default n + help + On HS cores, taken interrupt auto saves the regfile on stack. + This is programmable and can be optionally disabled in which case + software INTERRUPT_PROLOGUE/EPILGUE do the needed work + endif # ISA_ARCV2 endmenu # "ARC CPU Configuration" @@ -455,7 +450,6 @@ config HIGHMEM config ARC_HAS_PAE40 bool "Support for the 40-bit Physical Address Extension" - default n depends on ISA_ARCV2 select HIGHMEM select PHYS_ADDR_T_64BIT @@ -498,7 +492,6 @@ config HZ config ARC_METAWARE_HLINK bool "Support for Metaware debugger assisted Host access" - default n help This options allows a Linux userland apps to directly access host file system (open/creat/read/write etc) with help from @@ -526,22 +519,9 @@ config ARC_DW2_UNWIND config ARC_DBG_TLB_PARANOIA bool "Paranoia Checks in Low Level TLB Handlers" - default n endif -config ARC_UBOOT_SUPPORT - bool "Support uboot arg Handling" - default n - help - ARC Linux by default checks for uboot provided args as pointers to - external cmdline or DTB. This however breaks in absence of uboot, - when booting from Metaware debugger directly, as the registers are - not zeroed out on reset by mdb and/or ARCv2 based cores. The bogus - registers look like uboot args to kernel which then chokes. - So only enable the uboot arg checking/processing if users are sure - of uboot being in play. - config ARC_BUILTIN_DTB_NAME string "Built in DTB" help @@ -555,24 +535,4 @@ config FORCE_MAX_ZONEORDER default "12" if ARC_HUGEPAGE_16M default "11" -menu "Bus Support" - -config PCI - bool "PCI support" if MIGHT_HAVE_PCI - help - PCI is the name of a bus system, i.e., the way the CPU talks to - the other stuff inside your box. Find out if your board/platform - has PCI. - - Note: PCIe support for Synopsys Device will be available only - when HAPS DX is configured with PCIe RC bitmap. If you have PCI, - say Y, otherwise N. - -config PCI_SYSCALL - def_bool PCI - -source "drivers/pci/Kconfig" - -endmenu - source "kernel/power/Kconfig" |