aboutsummaryrefslogtreecommitdiffstats
path: root/Documentation/spi/pxa2xx
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/spi/pxa2xx')
-rw-r--r--Documentation/spi/pxa2xx10
1 files changed, 5 insertions, 5 deletions
diff --git a/Documentation/spi/pxa2xx b/Documentation/spi/pxa2xx
index 13a0b7fb192f..551325b66b23 100644
--- a/Documentation/spi/pxa2xx
+++ b/Documentation/spi/pxa2xx
@@ -21,15 +21,15 @@ Typically a SPI master is defined in the arch/.../mach-*/board-*.c as a
"platform device". The master configuration is passed to the driver via a table
found in include/linux/spi/pxa2xx_spi.h:
-struct pxa2xx_spi_master {
+struct pxa2xx_spi_controller {
u16 num_chipselect;
u8 enable_dma;
};
-The "pxa2xx_spi_master.num_chipselect" field is used to determine the number of
+The "pxa2xx_spi_controller.num_chipselect" field is used to determine the number of
slave device (chips) attached to this SPI master.
-The "pxa2xx_spi_master.enable_dma" field informs the driver that SSP DMA should
+The "pxa2xx_spi_controller.enable_dma" field informs the driver that SSP DMA should
be used. This caused the driver to acquire two DMA channels: rx_channel and
tx_channel. The rx_channel has a higher DMA service priority the tx_channel.
See the "PXA2xx Developer Manual" section "DMA Controller".
@@ -51,7 +51,7 @@ static struct resource pxa_spi_nssp_resources[] = {
},
};
-static struct pxa2xx_spi_master pxa_nssp_master_info = {
+static struct pxa2xx_spi_controller pxa_nssp_master_info = {
.num_chipselect = 1, /* Matches the number of chips attached to NSSP */
.enable_dma = 1, /* Enables NSSP DMA */
};
@@ -206,7 +206,7 @@ DMA and PIO I/O Support
-----------------------
The pxa2xx_spi driver supports both DMA and interrupt driven PIO message
transfers. The driver defaults to PIO mode and DMA transfers must be enabled
-by setting the "enable_dma" flag in the "pxa2xx_spi_master" structure. The DMA
+by setting the "enable_dma" flag in the "pxa2xx_spi_controller" structure. The DMA
mode supports both coherent and stream based DMA mappings.
The following logic is used to determine the type of I/O to be used on