diff options
Diffstat (limited to 'Documentation/hwmon/shtc1')
| -rw-r--r-- | Documentation/hwmon/shtc1 | 43 |
1 files changed, 0 insertions, 43 deletions
diff --git a/Documentation/hwmon/shtc1 b/Documentation/hwmon/shtc1 deleted file mode 100644 index 6b1e05458f0f..000000000000 --- a/Documentation/hwmon/shtc1 +++ /dev/null @@ -1,43 +0,0 @@ -Kernel driver shtc1 -=================== - -Supported chips: - * Sensirion SHTC1 - Prefix: 'shtc1' - Addresses scanned: none - Datasheet: http://www.sensirion.com/file/datasheet_shtc1 - - * Sensirion SHTW1 - Prefix: 'shtw1' - Addresses scanned: none - Datasheet: Not publicly available - -Author: - Johannes Winkelmann <johannes.winkelmann@sensirion.com> - -Description ------------ - -This driver implements support for the Sensirion SHTC1 chip, a humidity and -temperature sensor. Temperature is measured in degrees celsius, relative -humidity is expressed as a percentage. Driver can be used as well for SHTW1 -chip, which has the same electrical interface. - -The device communicates with the I2C protocol. All sensors are set to I2C -address 0x70. See Documentation/i2c/instantiating-devices for methods to -instantiate the device. - -There are two options configurable by means of shtc1_platform_data: -1. blocking (pull the I2C clock line down while performing the measurement) or - non-blocking mode. Blocking mode will guarantee the fastest result but - the I2C bus will be busy during that time. By default, non-blocking mode - is used. Make sure clock-stretching works properly on your device if you - want to use blocking mode. -2. high or low accuracy. High accuracy is used by default and using it is - strongly recommended. - -sysfs-Interface ---------------- - -temp1_input - temperature input -humidity1_input - humidity input |