diff options
Diffstat (limited to 'Documentation/hwmon/ina2xx.rst')
-rw-r--r-- | Documentation/hwmon/ina2xx.rst | 31 |
1 files changed, 25 insertions, 6 deletions
diff --git a/Documentation/hwmon/ina2xx.rst b/Documentation/hwmon/ina2xx.rst index 94b9a260c518..27d2e39bc8ac 100644 --- a/Documentation/hwmon/ina2xx.rst +++ b/Documentation/hwmon/ina2xx.rst @@ -11,7 +11,7 @@ Supported chips: Datasheet: Publicly available at the Texas Instruments website - http://www.ti.com/ + https://www.ti.com/ * Texas Instruments INA220 @@ -21,7 +21,7 @@ Supported chips: Datasheet: Publicly available at the Texas Instruments website - http://www.ti.com/ + https://www.ti.com/ * Texas Instruments INA226 @@ -31,7 +31,7 @@ Supported chips: Datasheet: Publicly available at the Texas Instruments website - http://www.ti.com/ + https://www.ti.com/ * Texas Instruments INA230 @@ -41,7 +41,7 @@ Supported chips: Datasheet: Publicly available at the Texas Instruments website - http://www.ti.com/ + https://www.ti.com/ * Texas Instruments INA231 @@ -51,7 +51,7 @@ Supported chips: Datasheet: Publicly available at the Texas Instruments website - http://www.ti.com/ + https://www.ti.com/ Author: Lothar Felten <lothar.felten@gmail.com> @@ -74,7 +74,7 @@ bus supply voltage. The shunt value in micro-ohms can be set via platform data or device tree at compile-time or via the shunt_resistor attribute in sysfs at run-time. Please -refer to the Documentation/devicetree/bindings/hwmon/ina2xx.txt for bindings +refer to the Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml for bindings if the device tree is used. Additionally ina226 supports update_interval attribute as described in @@ -99,6 +99,25 @@ Sysfs entries for ina226, ina230 and ina231 only ------------------------------------------------ ======================= ==================================================== +in0_lcrit Critical low shunt voltage +in0_crit Critical high shunt voltage +in0_lcrit_alarm Shunt voltage critical low alarm +in0_crit_alarm Shunt voltage critical high alarm +in1_lcrit Critical low bus voltage +in1_crit Critical high bus voltage +in1_lcrit_alarm Bus voltage critical low alarm +in1_crit_alarm Bus voltage critical high alarm +power1_crit Critical high power +power1_crit_alarm Power critical high alarm update_interval data conversion time; affects number of samples used to average results for shunt and bus voltages. ======================= ==================================================== + +.. note:: + + - Configure `shunt_resistor` before configure `power1_crit`, because power + value is calculated based on `shunt_resistor` set. + - Because of the underlying register implementation, only one `*crit` setting + and its `alarm` can be active. Writing to one `*crit` setting clears other + `*crit` settings and alarms. Writing 0 to any `*crit` setting clears all + `*crit` settings and alarms. |