1 files changed, 0 insertions, 66 deletions
diff --git a/Documentation/devicetree/bindings/display/panel/samsung,ld9040.txt b/Documentation/devicetree/bindings/display/panel/samsung,ld9040.txt
deleted file mode 100644
index 354d4d1df4ff..000000000000
--- a/Documentation/devicetree/bindings/display/panel/samsung,ld9040.txt
+++ /dev/null
@@ -1,66 +0,0 @@
-Samsung LD9040 AMOLED LCD parallel RGB panel with SPI control bus
-
-Required properties:
-  - compatible: "samsung,ld9040"
-  - reg: address of the panel on SPI bus
-  - vdd3-supply: core voltage supply
-  - vci-supply: voltage supply for analog circuits
-  - reset-gpios: a GPIO spec for the reset pin
-  - display-timings: timings for the connected panel according to [1]
-
-The panel must obey rules for SPI slave device specified in document [2].
-
-Optional properties:
-  - power-on-delay: delay after turning regulators on [ms]
-  - reset-delay: delay after reset sequence [ms]
-  - panel-width-mm: physical panel width [mm]
-  - panel-height-mm: physical panel height [mm]
-
-The device node can contain one 'port' child node with one child
-'endpoint' node, according to the bindings defined in [3]. This
-node should describe panel's video bus.
-
-[1]: Documentation/devicetree/bindings/display/panel/display-timing.txt
-[2]: Documentation/devicetree/bindings/spi/spi-bus.txt
-[3]: Documentation/devicetree/bindings/media/video-interfaces.txt
-
-Example:
-
-	lcd@0 {
-		compatible = "samsung,ld9040";
-		reg = <0>;
-		vdd3-supply = <&ldo7_reg>;
-		vci-supply = <&ldo17_reg>;
-		reset-gpios = <&gpy4 5 0>;
-		spi-max-frequency = <1200000>;
-		spi-cpol;
-		spi-cpha;
-		power-on-delay = <10>;
-		reset-delay = <10>;
-		panel-width-mm = <90>;
-		panel-height-mm = <154>;
-
-		display-timings {
-			timing {
-				clock-frequency = <23492370>;
-				hactive = <480>;
-				vactive = <800>;
-				hback-porch = <16>;
-				hfront-porch = <16>;
-				vback-porch = <2>;
-				vfront-porch = <28>;
-				hsync-len = <2>;
-				vsync-len = <1>;
-				hsync-active = <0>;
-				vsync-active = <0>;
-				de-active = <0>;
-				pixelclk-active = <0>;
-			};
-		};
-
-		port {
-			lcd_ep: endpoint {
-				remote-endpoint = <&fimd_dpi_ep>;
-			};
-		};
-	};